Outdoor Essentials CHILDREN'S PICNIC TABLE Instrucciones De Montaje

• 1 – Pre-assembled tabletop (A)
• 1 – Pre-assembled bench seating (B)
• 4 – Predrilled table legs (C)
• 8 – 4" Machine bolt (D)
• 16 – 1/4" Washers (E)
• 8 – 1/4" Nuts (E)
• 8 – Nylon bolt protectors/covers
Items you will need
• 7/16" wrench (x2)
• Gloves
• Safety glasses
ADULT ASSEMBLY REQUIRED
For ages 3 — 8 years or older.
When unassembled, this package contains small parts that are a
choking hazard. Hardware may contain sharp edges and points.
Keep away from children until assembled. Protect your eyes.
Always wear safety glasses during assembly.
Weight is limited to two 75-lb. children per side
(150-lb. maximum per side). Table top is limited to
40-lb. maximum. Sitting on the table top is not
advised for safety reasons.
Remove hardware from packaging. Place tabletop (A) and bench
seat (B), stacked, face down on a work surface.
With bench seat supports stacked on the underside of the tabletop
supports, position the legs (C) so the predrilled holes align with the
predrilled holes of the tabletop support. Gently insert the provided
4" machine bolts with washers (D) into the predrilled holes and
secure with a washer and nut (E). Repeat steps for the remaining
legs (fig. 1).
Steps 3 and 4
Lift one bench seat and align with the predrilled holes on the
assembled legs. Attach the bench seat with 4" machine bolts with
washers (D) and gently secure with a washer and nut (E). Repeat
steps for opposite side bench seat (figs. 2 and 3). Slip nylon bolt
protectors over the ends of the 4 bolts that attach the seats to the legs.
Once you've inserted all bolts, washers and nuts, carefully flip the
table right-side up and ensure that it's level. Securely tighten all
nuts.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR USE OF
THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE CONSTRUCTION OR USE
OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT, INCLUDING, BUT NOT LIMITED TO,
WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS
OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
©2017 UFP Janesville, LLC. Outdoor Essentials is a registered trademark of Universal Forest Products, Inc. All rights reserved. 9212_4/17
Contents
• Tape measure
• Hammer or mallet for tapping
bolts into predrilled holes
Step 1
Step 2
Step 5
UFP Janesville LLC | 1118 U.S. Highway 14 East | Janesville, WI 53545 | 608-755-6200
CHILDREN'S PICNIC TABLE
ASSEMBLY INSTRUCTIONS
B
UFPJanesville.com
A
D
E
C
PicTable5c.ai
PicTable2c.ai
PicTable3c.ai
PicTable4c.ai
fig. 1
fig. 2
fig. 3