Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1: FRAME ASSEMBLY CONTINUED
2. Using (6) 3/8-16 x 1¼" hex head cap screws and
self-locking nuts, bolt the top of back panel (F) to
the insides of L1. (See Figure 1)
3. Bolt the bottom of back panel (F) to base panel (E)
on the insides of L2. (See Figure 1)
4. Bolt base panel (E) to the insides of L3. (See Figure 1)
STEP 2: INSTALL HANDRAILS
NOTE: DO NOT tighten bolts until instructed to.
1.
With ladder on its side, install side handrail (A) into
rear stile tubes. Use the rubber mallet as needed for
mating parts. (See Figure 2, Step 1)
2. Detach handrail brackets that are shipped attached
to the handrails.
Figure 2
C
Rear
Handrail
Bar
STEP 3: INSTALL REAR HANDRAIL BAR
1.
Detach rear handrail bar (C) that is taped to the
handrail.
2. Insert notched bushing into each end of rear
handrail bar (C).
3. Position rear handrail bar between mounting holes of
side handrails (A) & (B). Attach using (2) 1/4-20 x 2¾"
hex head cap screws. (See Figure 2, Step 3)
NOTE: You may now tighten all handrail bolts.
PAGE 2 OF 6
ASSEMBLY CONTINUED
1/4-20 x 2¾"
H.H.C.S.
Side
Handrail
Notched
Step 3
Bushing
L1
Single Hole
Model
L1
Double Hole
Model
3. Clamp side handrails outside of stile tubes using
detached handrail brackets and 3/8-16 x 2" hex
head cap screws, gray bushings and self-locking nuts
(See Figure 2, Step 2)
4. Repeat step 2 with side handrail (B).
Tube Cap
Stairway
Handrail
Rear Stile
Tube
Step 1
A, B
D
STEP 4: LEVEL LADDER
1.
Stand ladder upright on level surface.
2. Activate safelock by stepping on trip bar located in
front of first step.
3. Make sure ladder rests level on the crutch tips and
rubber bumpers.
4. When steps are level, tighten all bolts.
NOTE: DO NOT proceed until ladder is stable.
1-800-295-5510
uline.com
Figure 1
F
D
E
L1
L2
Handrail
Handrail
Bracket
Tubes
3/8-16
Self-locking
Nut
Gray
Step 2
Bushing
3/8-16 x 2"
H.H.C.S.
Trip Bar
Single Hole
Model
L3
L3
Double Hole
Model
L3
0521 IH-3130U-12
Publicidad
