Publicidad
Idiomas disponibles
Idiomas disponibles
b. When the mounting height is more than 5 feet,
the cord opening should face downward.
(See Figure 4)
7.
Slide mounting pin through bracket and reel.
(See Figure 4)
WARNING: Slide locking pin through mounting
pin for security. It will prevent mounting pin
from sliding out of position. (See Figure 4)
Figure 4
Wall
Locking Pin
CEILING MOUNTING
1.
Pick approximate location for the reel within 2½ feet
of a 110-125V standard outlet.
2. Locate joist or beam to install mounting bracket.
Place bracket directly over center of joist or beam.
3. Using bracket as a template, mark three screw
locations with pencil. (See Figure 5)
Figure 5
2½"
Bracket Hole Pattern
PAGE 2 OF 6
INSTALLATION CONTINUED
Mounting Pin
Cord Opening
2½"
4. Pre-drill three screw holes using a 1/4" drill bit. Holes
should be at least 2" deep.
5. Install bracket with three provided hex head wood
screws and washers using a 1/2" wrench or socket.
Tighten all screws. (See Figure 6)
NOTE: When ceiling mounting is to be against
a steel beam, a professional installer should
use minimum 1/4" bolts with lock washers or
locking nuts.
Figure 6
Bracket
Hex Head Wood Screws
6. Install reel into bracket by sliding mounting pin
through bracket and reel. (See Figure 7)
WARNING: Slide locking pin through mounting
pin for security. It will prevent mounting pin
from sliding out of position. (See Figure 7)
Figure 7
Locking Pin
Ceiling
Mounting Pin
0521 IH-5644
Publicidad
