Baja Motorsports AT250UT Guía De Armado página 7

INSTALLING REAR SHOCK
 Locate rear shock hardware as described in the Loose
Parts List on page 5.
 Place rubber grommets on each side of shock. The beveled
portion of the grommet should face in toward the shock.
 Place shock in frame bracket on ATV and install shock
pin.
 Slide metal washer on the end of the shock pin, then install
cotter pin. The ends of the cotter pin should be bent over
to secure in place.
WARNING:
If any parts are damaged or missing do not assemble
this product until the parts are replaced with new original
manufacturer's parts or their equivalent. Assembly of this
product with damaged, missing, or incorrect parts could
result in serious personal injury.
All manuals and user guides at all-guides.com
ASSEMBLY
INSTALLING HANDLEBAR
 Locate handlebar hardware as described in the Loose
 Place bottom bracket under handlebars and align bolt
 Place top brackets over handlebars and align bolt
 Insert both bracket bolts and finger tighten.
 Lift handlebars to proper operating position. Tighten handle
 Turn the handlebars fully left and right to verify proper
7 — English
Parts List on page 5.
holes.
holes.
WARNING:
If any parts are damaged or missing do not assemble
this product until the parts are replaced with new original
manufacturer's parts or their equivalent. Assembly of this
product with damaged, missing, or incorrect parts could
result in serious personal injury.
bar bolts securely. Torque to 20 ft.lbs. (27 Nm).
WARNING:
Strictly adhere to all torque wrench tightening specifi-
cations. Failure to do so may cause serious personal
injury.
operation and to make sure the throttle cable, brake hoses,
and other wires are not squeezed or pulled too tightly.
WARNING:
Failure to correctly install and verify proper operation of
the handlebars could cause a loss of control when operat-
ing the ATV, which may result is serious injury or death.