Descargar Imprimir esta página

Navibe Back Track Manual Del Usuario página 16

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
All manuals and user guides at all-guides.com
2. To mark the location (store it in the Back Track's memory under your selected, Location icon), hold the
MARK button until the distance indication changes to "0". It does not matter which direction you face
when marking the location (as a stored GPS location is just a point or "dot"). When you move away from
that location, an arrow points the way back to the location (general direction relative to your current
position), and the display shows your distance from the location. You may now turn the Back Track's
power off by holding down the MODE/Power button, or proceed to another location you want to mark. Be
sure to select a different Location icon before marking this new spot, as holding MARK with a previously
used Location icon selected will replace that position with your current location.
3. When you're ready to return to one of your previously marked locations, turn the Back Track back on
(Hold the MODE/Power button). The Back Track will remember the last mode and location you used, so
if the last place you marked was your car in a parking lot, the Back Track will already be showing you the
direction and distance back to your car! If you want to return to a location other than the last one you
marked, just push the MODE/Power button to select the Location icon you used when you marked it
earlier. To find your way back to the selected location, simply move in the direction the arrow points and
watch for the distance to decrease-when you reach your destination, a full circle of arrows will be seen at
the outer edge of the display.
16

Publicidad

loading