Field Controls ELIMINATOR EL-1 Manual De Instrucciones página 2

MOUNTING LOCATION AND MOUNTING REQUIREMENTS
1. Locate fan on crawl space vent areas that do not have good cross flow
ventilation.
TM
2. The ELIMINATOR
space vent that has a grill mesh construction (see mounting instructions).
3. One unit is recommended per 1,000 square feet of crawl space. The actual
total number of units will be based on moisture removal requirements of the
crawl space.
MOUNTING INSTRUCTIONS
1. Remove any manual covering door on the crawl space vent where the unit is
to be installed. (See Figure 1) If plastic automatic vents are used, remove
the closure vanes before installing fan onto vent. (See Figure 2)
TM
2. Hold ELIMINATOR
the backing screen. This is to be done at the location where the slotted
mounting holes and the vent grill mesh intersect. (See Figure 3)
3. Secure ELIMINATOR
mounting anchors. Insert the flat edge of the mounting anchor through the
slotted holes in the ELIMINATOR
of the vent. Hold in place and install the supplied flat washer and hex nut.
After all four (4) mounting brackets are installed, tighten nuts. (See Figure
4)
All manuals and user guides at all-guides.com
fan unit must be mounted onto an existing or new crawl
unit against the vent. Mark and poke 4 holes through
TM
to the grill mesh of the vent with the supplied
TM
mounting plate and hook the grill mesh
Figure 3
Page 2
Figure 1
Figure 2
Figure 4