Jocel JET-014801 Manual Del Usuario página 36

All manuals and user guides at all-guides.com
Temperature adjustable range is from 10 ℃ ~ 35 ℃.
If no buttons are pressed, the blinking will stop after 5 seconds and the setting will be finished
automatically.
2-1-3 Timer setting (timer mode)
Hold for 3 seconds until the symbol is shown.
At the same time the clock will turn to 00:00 and start to blink.
This means the timer setting starts as follows:
Press or to set the timer length, every button press will change half an hour (30 minutes).
The maximum timer length is 24 hours.
When the timer is over, the unit will enter into standby mode .
You can also set time and temperature the same as 2-1-1 and 2-1-2.
To quit from timer mode: hold the button for 3 seconds until the symbol has disappeared.
The unit will automatically return back to free normal mode afterward.
(Note: Once the machine exits free program (enter the day, week program, or standby), and then return
to the free program, the unit always enters into the free normal mode first. The original timing model will
be automatically cancelled).
2-2 running mode selecting
Press the button to get into program selecting (Program No. start to blink).
Press or to select running mode:
, ~ ,
Then press to confirm it .
The unit will run following the new selection program.
Note: During this period, if no buttons are pressed, the selection is automatically completed 5 seconds
later.
-33-