Publicidad
Guidelines for Good Reception:
• Place your Baby's Unit 4' to 6' (1.5 to 2 m) away from the baby.
• Be certain all three units are set on the same channel.
• Check reception regularly by following step 8.
• Adjust the volume to a comfortable level for your environment.
• Use the Parent Units far enough away from the Baby's Unit so as
not to get feedback.
• During use of the monitor, if the sound or picture quality deteriorates
you may be reaching the limits of the monitor's range. If this happens,
you will need to move the Parent Units in closer proximity to the
Baby's Unit.
• If one channel has poor reception try one of the other channels.
• Test the Automatic Night Vision (infra red sensors around the lens) by
darkening the room where the Baby's Unit is located.
NOTE: It is possible for the Parent Units to pick up sounds or display
interference from other signal producing devices which broadcast in
the 900 MH z frequency range. To minimize this potential problem,
two independent channels have been provided.
If you experience interference while using one channel setting,
simply switch all three units to another channel. Selecting a channel
is usually a one-time adjustment. If interference persists on all
channels, please refer to the Troubleshooting section at the end of
these instructions.
CAUTION: To protect your privacy, always turn the Baby's Unit off
when not in use. Always remember that you are using public
airwaves. Sound may be broadcast to other receiving devices.
Conversations, even from rooms nearby, may be broadcast.
Problem
Video monitor has no
sound/picture or static
Power/low battery indicator
is amber
Parent's Unit power
indicator does not illuminate
Audio feedback (squealing)
Power indicator does not
illuminate on Baby's Unit
Weak sound coming from
Parent's Unit
Parent's Unit is picking up
noises or displaying
interference from outside
your home
NOTE: Please do not return this product to the place of purchase. If you are having difficulty using this product, email consumer@djgusa.com, call
Consumer Relations at (800) 544-1108, or fax at (800) 207-8182. You can also visit our website at www.safety1st.com.
Possible Cause
Video is not turned on
Volume is too low
Channel switches are not on the same
setting (1 or 2)
Signal interference due to microwaves,
monitors, cellular or cordless telephones,
etc.
Out of range
Batteries are low
Parent's Unit is not turned on
Batteries are dead/Power is turned off
AC Adapter not properly connected
Parent's Unit is too close to the Baby's
Unit
Baby's unit is not turned on
AC Adapter not properly connected
Battery may be low
Baby is too far away from Baby's Unit
Parent's Unit is picking up noises from
outside your home
Pautas para tener buena recepción de sonido:
• La unidad del bebé debe colocarse a una distancia de 1.5 a 2 m (4 a 6 pies)
del niño, aproximadamente.
• Cerciórese de haber seleccionado el mismo canal en todas las unidades.
• Compruebe con regularidad la recepción siguiendo el paso 9 indicado
anteriormente.
• Ajuste el volumen a un nivel confortable para su entorno.
• Utilice la unidad de los padres suficientemente lejos de la unidad del
bebé para que no haya retroalimentación.
• Durante el uso del monitor, si la calidad del sonido o de la imagen empeora,
es probable que el monitor se encuentre cerca del límite de su alcance. Si
ocurre esto, tendrá que acercar la unidad de los padres a la unidad del bebé.
• Si un canal tiene mala recepción pruebe el otro canal.
• Pruebe la función de visión nocturna automática (sensores infrarrojos
ubicados alrededor de la lente) oscureciendo la habitación donde se
encuentre instalada la unidad del bebé.
NOTA: Es posible que la unidad de los padres capte sonidos o imágenes
de interferencia de otros dispositivos que producen señales y que
también transmiten en la banda de 2.4 GH
problema, se dispone de tres canales independientes.
Si usted experimenta interferencia durante el uso en un canal determinado,
simplemente cambie la unidad de los padres y la unidad del bebé a otro
canal. Por lo general, la selección del canal es un ajuste que se realiza una
sola vez. Si la presencia de interferencias en el canal preprogramado es
constante, consulte la sección "Localización de averías" al final de estas
instrucciones.
PRECAUCIÓN: Para proteger su privacidad, apague siempre la unidad del
bebé cuando no la esté utilizando. Recuerde siempre que está usando onda
públicas. El sonido se puede transmitir a otros dispositivos de recepción.
Las conversaciones, incluso de habitaciones cercanas, se pueden transmitir.
Troubleshooting
Solution
Turn video on at the side of the Parent's Unit
Adjust the volume control on the Parent's Unit
Check the channel switches on the Baby's Unit and Parent's Unit to confirm they
are on the same channel (1 or 2)
Try one of the other channels
Bring video monitor closer to Baby's Unit
Change batteries
Push the button on the front of Parent's Unit to the on position
Change batteries / Make certain that any light switches that control the power
flow to the wall outlet are on (when using AC).
Check AC Adapter jack-to-socket and plug-to-outlet connections
Move the Parent's Unit further away from the Baby's Unit
Lower the volume on the Parent's Unit
Slide the button on the back of the Baby's Unit to channel 1 or 2
Make certain that any light switches that control the power flow to the wall outlet
are on (when using AC)
Check AC Adapter jack-to-socket and plug-to-outlet connections
Change batteries
Move the Baby's Unit within 4' to 6' of Baby
Change both the Parent's and Baby's Units to an alternate channel (1 or 2)
8
z
. Para minimizar este posible
Publicidad
