Dorel Juvenile Safety 1st 08051 Guia Del Usuario página 6

Operating Your Illumination Monitor
To Use the Baby's Unit and Parent's Unit:
4. Turn the Parent's Unit and the Baby's Unit On.
Adjust the channel on Parent's Unit to match the
channel on Baby's Unit (Figure 3).
5. Adjust the volume by turning the button on the
top of the Parent's Unit (Figure 3).
6. Check to be sure the Parent's Unit and Baby's Unit
are on the same channel (Figure 3).
Illumination:
7. The Illumination light has a 15-minute automatic
shut off. In order to activate the On/Off switch,
press the top (or the back) of the Baby's Unit
(Figure 4).Press again to shut off the Safe-Glow
light prior to the 15-minutes.
NOTE: The Illumination light has a long lasting bulb,
which is not replaceable.
Secure Sound Lights:
8. The 5 sound lights on the Parent's Unit indicate the
sound level of the baby. The more noise your baby makes,
the more sound lights will illuminate (Figure 5).
Power On/Low Battery Indicator:
9. The power on indicator on the Parent's Unit lights green.
If the batteries are low the light will change to amber.
Change batteries or use AC when amber light comes on
(Figure 5).
CAUTION: Test the Parent's Unit before each use. It is
essential to check reception regularly.
To Test the Reception:
10. Place the Baby's Unit at least 20' (6 m) away from Parent's
Unit. Have an adult speak into the Baby's Unit at various levels (soft to loud) while
another adult checks the Parent's Unit for the proper sound and reception. Try the
Parent's Unit in every location that it will be used. It is best to follow these guidelines
for good reception:
Guidelines for Good Reception:
• Place your Baby's Unit 4 to 6' (1.5 to 2 m) away from the baby.
• Adjust the volume to a comfortable level for your environment.
• Use the Parent's Unit far enough away from the Baby's Unit so as not to get feedback.
• During use of the monitor, if the sound quality deteriorates you may be reaching the limits of the
monitor's range. If this happens, you will need to move the Parent's Unit in closer proximity to
the Baby's Unit.
• If you have difficulty obtaining good sound quality, please refer to the Troubleshooting
section at the end of these instructions.
NOTE: It is possible for the Parent's Unit to pick up sounds or display interference from
other signal producing devices which broadcast in the 49 MHz frequency range. To
minimize this potential problem, two independent channels have been provided. If you
experience interference while using one channel setting, simply switch the Parent's Unit
6
3
On/Off
Volume
Control
On/Off
Channel Selector
4
Illumination
On/Off
Switch
5
Sound
Lights
Green - Power On
Amber - Batteries Low