PC Setup
You can adjust horizontal/vertical position, clock, phase,
and auto-configure, reset as you prefer.
D
Press the MENU button and then
the SETUP menu.
G
D
E
Press the
button and then
/
desired picture item.
F
G
Press the
/
button to make appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to left/right and up/down
as you prefer.
Clock
This function is to minimize any vertical bars or stripes vis-
ible on the screen background. And the horizontal screen
size will also change.
Phase
This function allows you to remove any horizontal noise
and clear or sharpen the image of characters.
WXGA (or VGA (Only RGB[DVI] mode))
a : When the set is inputted WXGA signal, select the desired WXGA resolution.
b : When the set is inputted DVI-480p signal in VGA mode, select 480p on the SETUP menu.
SETUP
SETUP
Language
Language
PC Control
PC Control
PC Control
WXGA
WXGA
VGA
VGA
Input
Input
ARC
ARC
()}{OOOKOOMENU
()}{OOOKOOMENU
Auto-configure
This function is for the automatic adjustment of the screen
position, clock and phase. The displayed image will disap-
E
/
button to select
pear for a few seconds while the Auto-configuration is in
progress.
button to select the
Reset
This function allows you to return to the good picture repro-
duction programmed at the factory and cannot be
changed.
Note : Some signal from some graphics boards may not
function properly. If the results are unsatisfactory, adjust
your monitor's position, clock and phase manually.
Press the OK button to store it for the PC monitor picture.
Press the EXIT button to return to PC mode.
H-Pos.
0
V-Pos.
0
Clock
50
Phase
50
Auto
Reset
SETUP
Language
1024X768
PC Control
1280X768
WXGA
WXGA
1360X768
VGA
1366X768
Input
ARC
()}{OOOKOOMENU
EN
29