General Information - Agilent Technologies 969-9258 Manual De Instrucciones

17 Instructions for Use

General Information

General Information

This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The Protocol Converter is exclusively developed for Agilent products
RS485 network. It can be connected to a common RS232 Com Port on
a PC and a Agilent products RS485 network. The following
paragraphs contain all the information necessary to guarantee the
safety of the operator when using the equipment. Detailed
information is supplied in the appendix "Technical Information".
This manual uses the following standard protocol:
The caution messages are displayed before procedures which, if not followed,
CAUTION!
could cause damage to the equipment.
The warning messages are for attracting the attention of the operator to a
WARNING! particular procedure or practice which, if not followed correctly, could lead to
serious injury.
The notes contain important information taken from the text.
NOTE
128/146 Protocol Converter RS232-485 User Manual / 87-900-974-01 (E)