Eagle Group 317754 Instrucciones Para El Ensamblaje

instruction sheet
#317754
insPect contents iMMeDiAteLY AnD FiLe cLAiM With DeLiVerinG cArrier For AnY DAMAGe.
You Are resPonsiBLe For DAMAGe to Your unit iF returneD i MProPerLY PAcKeD.
NSF
set screw
cap
Hardware is located in
plastic bag with brightly colored
"H RDW RE TT CHED" tape.
Step 1 - ssemble crossbrace subassembly.
• ssemble castings to end-to-end and front-to-back crossbracing, as shown.
• Tighten set screws* in the appropriate threaded hole in castings (see below).
*
To meet NS standards:
Either the supplied NSF
set screw caps must be
installed over all
exposed set screws, or
exposed set screws
must be filled with
silicone sealant.
Tables with six or more legs feature middle castings, additional crossbracing and additional
end castings. For clarity, these instructions show assembly for a table with FOUR legs.
SUBASSEMBLY FOR TABLE WITH SIX LEGS
eagle Foodservice equipment, eagle Mhc, specFAB, and retail Display are divisions of eagle Group. ©2016 by the eagle Group
Worktable with Tubular Base
ASSEMBLY INSTRUCTIONS
SAVE YOUR BOX AND ALL PACKING MATERIALS.
Hardware:
• 5/32˝ allen wrench
set
screw
casting
threaded hole
in casting for
crossbracing
set
screw
NSF set
screw cap
Please note:
SUBASSEMBLY FOR TABLE WITH EIGHT LEGS
middle casting
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S. . • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
CAUTION
Tool required:
corner casting
end
castings
front-to-back
crossbracing
middle castings
(continued on back page)
eG9805 revised 09/16
rear crossbracing
corner
casting