Omni International Bead Ruptor 4 Manual Del Usuario página 8

Changing the Tube Holder
1.
Turn unit off and unplug
power cord.
Changing the Neck Gasket
1.
Turn unit off and unplug the
power cord.
4.
Secure the new neck gasket
using the restriction tie with the
clamp positioned toward the
bottom of the instrument.
Tighten central screw.
All manuals and user guides at all-guides.com
2.
Use the supplied 3 mm
allen wrench to loosen tube
carriage holder screw
2.
Use the supplied 3 mm allen
wrench to loosen the central
screw and remove restriction tie
and old neck gasket.
5.
Use the supplied 3 mm allen
wrench to tighten the central
screw and secure the tube
carriage.
3.
Use the supplied 3 mm allen
wrench to tighten tube
carriage holder screw
3.
Slide the new neck gasket onto
the pivot shaft and housing