Installation Steps - AVS Aerovisor Deflector Instrucciones De Instalación

Installation Steps

Remove tape liner from the rear flange. Peel back 2" (5 cm) of
tape liner from each end of lateral flange and lower flange.
free end
3
rear
flange
Gently press the exposed areas of tape against the surface and
verify position.
5
Apply pressure along all flanges to ensure proper adhesion of tape.
7
Peel back 2" (5 cm) of tape liner from each flange end.
free end
9
NOTE: Actual application may vary slightly from illustrations.
lateral flange
free end
lower flange
free end
Align the visor on the door. The lateral flange will attach
to the painted surface and the lower flange will attach
to the rubber surface adjacent to the mirror. Install the
foam tape between the mirror base plate and the visor.
mirror base
Install foam
between
mirror base
4
plate and
visor
With the visor in its final position, remove the remaining tape liner
6
4 Piece Set
8
Align the visor on the door. The entire part applies to the painted
10
Page 2 of 3
by pulling on free ends.
Clean the entire painted surface along the
top edge of the door with an alcohol pad.
surface.