4.
Activate the rangefinder
Press the « ON» button for approximately ½ second to activate the LCD display.
5.
Adjusting the eyepiece
You have to adjust diopter in order to obtain a clear image in the LCD display.
- Rotate
the
counterclockwise until it comes to a complete stop.
- Press the « ON» button to activate the LCD display.
- Rotate the diopter adjustment ring clockwise until
the display comes into focus. If the diopter is not
adjusted to correspond to your eyesight, you may
not be able to correctly aim at your subject.
6.
Meter/yard switching
The range can be displayed in meters or yards, as desired. Use a short press on the « ON»
button to switch on the display and see the setting currently selected (M or Y). To change the
setting, press the « M » MODE button for approximately 1 second.
7.
Measuring modes
While looking through the rangefinder, press the « ON» button once to activate the LCD
screen. Place the aiming symbol (located in the center of the field of view) upon a target at
least 4 yards/meters away and then press the « ON» button again for approximately 3
seconds then release to display the distance measurement. You can press the « ON» button
again at any time to measure distance to a new target. If taking a measurement is not possible
because the range has been exceeded or because of insufficient target reflectivity, no
measurement will be displayed on the LCD screen. Repeat until a new measurement is
possible. After measurement, the measured result is displayed for approximately 15 seconds,
then the rangefinder switches off automatically when the display goes off.
8 operating modes are available:
- Ranging mode
- Scan
- Flagpole lock mode
- Distance correction mode
- Fog mode
- Horizontal distance measurement mode
- Vertical height measurement mode
- Speed mode
TEL1050 - Indice A – Avril 2020
diopter
adjustment
ring
13/47