König SAS-ALARMDW01 Manual De Usuario página 4

SAS-ALARMDW01
Stand-alone door/window-alarm
- Place the main unit on the frame and the magnetic part next to the main unit on the door/
window with the included double-sided adhesive tape:
- align arrows on both parts
- distance between main unit and magnet < 10 mm
- suggested height between 1.80 - 2.40 m
- Use the ON/OFF switch to activate the alarm.
- Short press the SET button to select the desired mode. The number of beeps indicates the
mode the product is in:
1. Default Alarm: When the door is opened, alarm sounds for 1 minute or until
SET button is pressed.
2. Doorbell
3. Open alarm: While the door is opened, alarm sounds until door is closed again.
4. Reminder: While the door is opened, a slowly increasing reminder signal
(short beeps) sounds until door is closed again.
Specifications:
Operating voltage:
Environment humidity:
Operating temperature:
Safety
• To reduce risk of electric shock, this product should only be opened by an authorized
technician when service is required.
• Read the manual carefully before use. Keep the manual for future reference.
• Only use the device for its intended purposes. Do not use the device for other purposes
than described in the manual.
• Do not use the device if any part is damaged or defective. If the device is damaged or
defective, replace the device immediately.
• The device is suitable for indoor use only. Do not use the device outdoors.
• Do not expose the product to water or moisture.
Cleaning and maintenance
Warning!
• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the device does not operate correctly, replace it with
a new device.
• Clean the outside of the device using a soft, damp cloth.
4.5 V (3 LR4 button batteries)
< 90%
-10 ~ 60 °C
4