Troubleshooting Guide; Important - Intex ZX300 Deluxe Automatic Manual Del Propietário

(178IO) ZX300 DELUXE AUTOMATIC POOL CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 08/21/2020

TROUBLESHOOTING GUIDE

TROUBLE
AUTo clEAnEr
DoEsn'T moVE
moVEmEnT is
VEry sloW
clEAnEr cAn noT
climB ThE pool
WAll
cAn noT pick Up
ThE lEAVEs on
pool floor
TAkEs lonGEr
TimE To rEVErsE
DirEcTion
If you continue to experience difficulty, please contact our Consumer Service Department
for assistance. See separate "Authorized Service Centers" sheet.
S AVE THESE INSTRUCTIONS
• Ensure the filter pump is operating and within the
specified pump flow rate [1600 - 3500 gallons/hour
(6056 - 13248 liters/hour)].
• Lift the auto cleaner out of the water and check if water
is flowing out from the "water outlet" located on the top
of the device.
• Tighten the hose collar nut securely, and connect
the hose to the water return connector, see "setup"
section. if you are not sure which return connector is,
try connecting the auto cleaner to each pool outlet until
water is flowing out from the "water outlet".
• remove the cleaner base, check if the gear box is
stuck, turn the wheels by hand and see if the wheels
rotate, if not, replace a new unit.
• contact intex service center.
• check and clean the debris net and micro-screen.
• clean or replace the filter pump cartridge.
• if using a sand filter, ensure the sand media is clean
by backwashing it. see sand filter owner's manual.
• pool water too dirty or the wall is covered with algae.
Ensure the pool water chemistry is balanced. if the pool
water is green, brown or black, adjust the chlorine and
ph level. see pool owner's manual.
• check if the pump flow rate is within the specified
range, if the flow rate is less than 1600 gal/h
(6056 liters/h), change the pump with a higher pump
flow rate.
• remove the brushes from the underside and put the
Auto cleaner back into the pool, see "setup" section.
• clean the debris net and micro-screen from the Auto
cleaner after operating for 2-3 hours continuously.
• This is normal, as the auto cleaner reversing time is
dictated by the size of the filter pump flow rate.

IMPORTANT

Page 16
SOLUTION
178A