Checking Operation; Before You Call For Service - Frigidaire FEB24S2AB Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
3. Use the remaining 2 screws for mounting the
appliance in the upper two mounting holes on each
side of the oven frame, above the door.
Figure 6
4.Pull out the oven approximately 1 foot (30.5 cm) away
from the cabinet. Reposition each bracket on the cabinet
and drill 1/8" pilot holes. Fasten the brackets in place
using the 2 screws supplied (#10 x 1
If needed, add wood spacers at the mounting bracket
locations to reduce the cabinet opening to 28
(72.4cm).
Now push the unit in and against the cabinet, then
attach the unit to the mounting brackets using the 2
screws removed earlier from the side frame.
6. Leveling the Wall Oven
1. Install an oven rack in the center of the upper oven
(see Figure 7).
2. Place a level on the rack. Take 2 readings with the
level placed diagonally in one direction and then the
other. Use wood shims under the wall oven to level if
necessary.
3. Repeat in the lower oven if you have a double cavity
wall oven. If the level indicates that the rack is not
level, use wood shims to reach a compromise for
both ovens.
Figure 7
All manuals and user guides at all-guides.com
MOUNTING
SCREW
DECORATIVE TRIM
(VENTILATION)
MOUNTING
SCREW
1
" long).
/
4
1
"
/
2

7. Checking Operation

Some wall ovens model have Manually Operated
Control Knobs to set the clock and the oven bake, broil
convection (some models) or clean functions. Refer to
the "Owner's Guide" or to the "Oven Control Guide"
supplied in the literature package and check all controls
for correct operation.
If your model is equipped with an Electronic Oven
Control. Each of the functions has been factory checked
before shipping. However, it is suggested that you verify
the operation of the electronic oven controls once more.
Refer to the Owner's Guide or to the Electronic Oven
Control Guide for operation. Follow the instructions for
the Clock, Timer, Preheat, Bake, Broil Convection (some
models) and Clean functions.
Bake–After setting the oven to 350°F/177°C for baking,
the lower element in the oven should become red.
Broil–When the oven is set to BROIL, the upper element
in the oven should become red.
Clean–When the oven is set for a self-cleaning cycle, the
upper element should become red during the preheat
portion of the cycle. After reaching the self-cleaning
temperature, the lower element will become red.
Convection (some models )–When the oven is set for
a convection baking or roasting, both elements cycle on
and off alternately and the convection fan will turn. The
convection fan will stop turning when the oven door is
opened during convection baking or roasting.
IMPORTANT NOTE: A fan inside the upper rear part
above the oven (some models) provides additional
cooling of the oven electrical and electronic components.
The fan will continue to run after the oven has been
operating at high temperatures.

Before You Call for Service

Read the Avoid Service Checklist and operating
instructions in your Owner's Guide. It may save you time
and expense. The list includes common occurrences that
are not the result of defective workmanship or materials
in this appliance.
Refer to the warranty in your Owner's Guide for our
toll-free service number and address. Please call or write
if you have inquiries about your product and/or need to
order parts.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido