Stereo Channel Section - SKP Pro Audio CRX-1010 El Manual Del Propietario

B. STEREO CHANNEL SECTION
12. LEFT (MONO) / RIGHT
Line with connection 1/4 jack as line input of L, R stereo and input
the signal of balance line level. If the signal input into the input
terminal of left side, output the mono output to left & right side. If
the signal input the input terminal of right side, output into the right
side only.
If each signal input the input terminal of left & right, output a stereo
of left & right.
13. TRIM
This has a function which adjusts the input sensitivity of each
channel in order to input the constant level of the signal.
14. LOW EQ
This control gives you up to 15 dB boost or cut at 80Hz and below.
This circuit is flat (no boost or cut) at the center detent position.
This frequency reptesents the punch in bass drums, bass guitar,
fat synth patches, and some really serious male singers.
15. MID EQ
Short for "midrange", this knob provides 12 dB of boost or cut,
centered at 2.5KHz, also flat at the center detent. Midrange EQ is
often thought of as the most dynamic, because the frequencies
that define any particular sound are almost always found in this
range. You can create many interesting and useful EQ changes
by turning this knob down as well as up.
4
15
14
13
12