Parts: K1
New
Ref.
Description
K1
K1
(1x) Quick Connects
K1.1
Quick Connects Red Wire
K1.2
Quick Connects Black Wire
K2
K2
(2x) Connector, 10-12 AWG
NI
A
Pump Assembly
A.1
Quick Connects Red Wire
A.2
Quick Connects Black Wire
NI
B
RV Power Source
B.1
Power Source Red Wire
NI
C
Fuse Holder / 35AMP Fuse
NI
NOT INCLUDED - Reference only.
Tools Needed:
■ Wire Cutter/Stripper
■ Wire Crimper
■ Heating Tool
Thetford Corporation recommends that only
AVIS
NOTICE
AVISO
ATTENTION
ATENCIÓN
CAUTION
DANGER
DANGER
!
!
!
!
!
a trained and qualified technician service this
ATTENTION
ATTENTION
ATTENTION
ATTENTION
product and plumbing and electrical work be
performed by a licensed tradesperson. Local
permit and code compliance is required.
Thetford Corporation accepts no responsibil-
ity or liability for damage to equipment, injury,
or death that may result from the system's
improper installation, service, or operation.
Be sure power has been disconnected before
you continue.
Questions?/Des questions?/¿Preguntas? 1-800-543-1219
P.O. Box 1285
Ann Arbor, MI 48106
www.thetford.com
300 Quick Connect Kit
K1
K2
Part No.
N° de pièce
Pieza n.°
+
B
B.1
PREPARE
■ Flush all debris from holding tanks.
■ Close all dump valves.
REMOVE PART
USE OLD PARTS:
B1
1.
Disconnect
from
A.1
2.
Disconnect
and
K1.1
3.
Disconnect
and
REPLACE PART
USE NEW PARTS:
Protect all wiring from foreign objects and
AVIS
NOTICE
AVISO
ATTENTION
CAUTION
ATENCIÓN
DANGER
!
!
!
!
water with wire sheath (not provided).
ATTENTION
ATTENTION
ATTENTION
K1
1.
Cut
in half.
2.
Crimp wires connecting
Be sure the quick connect plug
NOTICE
the socket end for the negative (black) wire.
.
3.
Crimp wires connecting
Be sure the
NOTICE
has the socket end for the positive (red) wire.
B.1
B
4.
Connect
to
.
A
5.
Power up
; verify voltage at motor is 12V.
Improper installation may damage motor or
AVISO
AVIS
NOTICE
CAUTION
!
decrease motor efficiency.
1
Made in the U.S.A.
Fabriqué aux É.-U.
Hecho en EE. UU.
K1.2
A.1
C
K1
A.2
K1.1
B
.
A.2
K1
from
.
K1.2;
K1
discard
.
K1
A.1
A.2.
plug to
and
K1
K1
K1.1
K1.2.
plug to
and
K1
plug going to the power source
Form/Formulaire n°/Formulario n.° 97638 Rev. A 04.25.17
97606
A
A
for
has