Installing The Hardware - Aleratec RoboRacer MultiDrive SA Guia De Inicio Rapido

Installing the Hardware

1. Remove the 1:3 DVD/CD RoboRacer MultiDrive SA from the box. Connect
the power cord to the machine. Connect the power cord into an appropriate
power source. Place the RoboRacer SA on a level surface.
2. Slide the side bin holder into the slot on the right side of the RoboRacer
MultiDrive SA case and place a disc output bin into the bin holder. Bad discs
will be deposited into this side disc bin. The RoboRacer MultiDrive SA has a
bin holder that mounts to the front of the unit. It should be placed at the edge
of a desk or table. The bin holder will hang over the edge of the desk or table.
Make sure that the bin does not touch the edge of the desk or table surface.
Make sure to keep the output bins that come with the 280118. Although similar
to a normal disc media cover, the Disc Output Bins are for specific use with the
RoboRacer MultiDrive SA. When installing, make sure that the flanges on the
bin are touching the lip of the bin holder. If the bin is not pushed down as far
as it can go, the edge of the bin could interfere with the disc output.
3. Take the clear plastic disc guide rods and place them into the 4 holes in the
top of the unit. To load the discs into the input bin, take one disc and place it
horizontally level in the input bin. Now you can load the rest of the discs. All
of the discs need to be level with the sides of the stack straight.
4. Save the box and packaging material for return shipment should your unit
require service.
Note: Choose a Good Location
1. Allow adequate clearance for moving parts.
2. When placing the duplicator on the side/edge of a tabletop
ensure that all four foot pads are in complete contact with the
surface of the table.
3. Do not place near heat sources such as radiators or air
ducts, or in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
4. Good care will help assure maximum product life. Improper
operating environment and misuse may void the warranty.
5. Turn the duplicator off and leave unplugged when not in use.
2 www.aleratec.com