Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
2-IN-1 Drip Filter/
Pressure Regulator with
1/2" Drip-Lock
Instructions
For outdoor use with cold water only.
Check local codes for installation requirements
If static water pressure exceeds 80 PSI, a pressure regulator should be
installed on the main sprinkler line.
Pressure test all water lines before covering pipe and timer control wire.
Warning: DO NOT use pipe dope on threads, use thread seal tape.
Step 1: Put 5 complete turns of tape
around the threads of each end of the
Filter Pressure Regulator
All manuals and user guides at all-guides.com
Adapter
®
Congratulations on your purchase of the Orbit
Filter Pressure Regulator. This revolutionary product
allows you to convert your 1" FPT irrigation valve into
a low pressure drip valve.
Features:
200 Mesh (removable) filter
30 Psi pressure regulator
I" MPT Inlet/outlet
Included 1"x1/2" FPT Drip-Lock
Important Guidelines
Installation Instructions
Step 2: Thread the Filter Pressure Regulator into
the valve until snug. Important: ensure that the
water flow arrow and pressure regulator point
away from the valve and towards the sprinkler pipe.
If desired, thread the adapter onto the pressure
regulated side of the 2-in-1 filter.
2-in-1
®
Adapter
®
pressure
regulator
Publicidad
Resumen de contenidos para Orbit Drip-Lock
- Página 1 2-IN-1 Drip Filter/ Pressure Regulator with 1/2" Drip-Lock Adapter ® Instructions Congratulations on your purchase of the Orbit 2-in-1 ® Filter Pressure Regulator. This revolutionary product allows you to convert your 1" FPT irrigation valve into a low pressure drip valve.
- Página 2 Filter Housing Filter Housing O-Ring Filter Body Filter O-Rings Filter Receiver Pressure Regulator Assembly 1" FPT 1/2" Drip-Lock Adapter ® Maintenance Monthly Use the flush port to clean large debris from the filter (adjust frequency based on water conditions). Before flushing ensure that the timer is in the OFF position. Next, remove the flush cap and attach a garden hose to the filter housing.
- Página 3 DE 1/2" ® Felicitaciones por la compra del filtro regulador de presión del filtro 2 en 1 de Orbit . Este producto revolucionario le permite convertir su ® válvula de irrigación para rosca de tubo hembra (FPT) de 1" en una válvula de goteo de baja presión.
- Página 4 Carcasa del filtro Junta tórica de la carcasa del filtro Estructura del filtro Juntas tóricas del filtro Receptor del filtro Ensamble del regulador de presión Adaptador Drip-Lock de 1/2" para ® rosca de tubo hembra (FPT) de 1" Mantenimiento Mensualmente Utilice el puerto de purga para limpiar los desechos grandes del filtro (ajuste la frecuencia en función de las condiciones del agua).