DeWalt DS620 Guia De Inicio Rapido

DS620 WIRELESS DOOR/WINDOW SENSOR
NOTE: This product works only with the DS600 Mobilelock™
GENERAL SAFETY RULES
WARNING: Read and understand all instructions and
warnings for this product.
In addition, read and follow all instructions and warnings provided
with the DS600 Mobilelock™ Portable Alarm System.
CAUTION: DANGER OF EXPLOSION, INJURY, OR FIRE.
Carefully follow all instructions and warnings on the battery label
and package.
• Never use a damaged or worn out battery.
• Discharged batteries should be replaced only with type
CR-123 3.0 Volt Lithium batteries.
• Do not use re-chargeable batteries or attempt to charge
batteries.
• Carefully remove the old, discharged battery.
• Do not attempt to open battery.
• Do not peel the label from the battery.
• Never dispose of a battery in a fire.
• Dispose of used batteries in accordance with local regulations.
• Recycle batteries.
• Always insert batteries correctly with regard to polarity
(+ and -) marked on the battery and the equipment.
• When installing the battery, do not use excessive force. If the
battery does not fit, check to make sure that it matches the
polarity markings.
• Never expose the battery terminals to any other metal object.
This can short circuit the battery.
• Avoid exposure to temperature extremes.
• When not in use, store the battery in a cool, dark, dry place.
• Keep batteries out of reach of children.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR
FAILURE. Do not use near water. Damage to the equipment
may occur. Equipment should not be exposed to liquids.
FCC REGULATORY STATEMENT (FCC: 2ABPY-BB4EA)
• This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) the device must accept
any interference received, including interference that may
cause undesired operation.
Components (Fig. 1)
A. Antenna
B. Reed Switch
C. Reset Button
Product Function
The DS620 Door/Window Contact Sensor is used for monitoring
opening of objects like doors or windows, or a gap of up to 3/8"
(9.5mm).
D. Tamper with spring
E. Magnet
FIG. 1
C
B
D
+
E
–
FIG. 3
E
F
Once activated, this device will work exclusively with the assigned
DS600 Mobilelock™ Portable Alarm System.
• The DS620 features BLE (Bluetooth
it to connect wirelessly to and only to the DS600 Mobilelock™.
Range between this sensor and the DS600 can be up to 100'
unobstructed (line of sight).
• The DS620 uses an internal reed switch (B) and magnet (E) for
door or window security.
• The DS620 features a tamper (D) that notifies the system when
the sensor cover is removed.
• The DS620 uses a CR-123 3.0V Lithium battery for long life.
• The reset button (C) should be depressed after each time a
battery is inserted.
NOTE: Metal objects blocking radio frequency (RF) transmission
can affect the range of the sensor.
A
FIG. 2
CAUTION: POTENTIAL
EQUIPMENT MALFUNCTION
OR FAILURE. Do not touch the
electronic components inside
the device, except the reset
button and battery.
FIG. 4
G G
Low Energy) that allows
®
F