Tips And Quick Fixes - Digital Signature MINT 300 Guia Del Usuario

T I P S A N D Q U I C K F I X E S
Where did the music go? Try these quick fixes:
1. Check the power connections.
2. Check the connection between the Mint
amplifier and the Mint speakers.
3. Make sure the correct source-selection button
is selected on the Mint amplifier or remote
control. The button should glow green.
4. Check the connections between the music
source and the Mint amplifier. For an iPod,
make sure it is properly seated in the dock.
5. Make sure that your music source is turned
on and that music is selected.
6. Turn up the volume. Make sure that mute
is not selected on any system component.
How do I replace the remote control battery?
Replace the battery when the remote stops
operating normally:
1. Place the tip of a pencil in the small slot at the
bottom of the remote. ull the tray open.
2. Replace with a CR2025 3-volt lithium battery.
3. Push tray closed until it clicks in to place.
4. Dispose of used battery properly. Do not
dispose in fire or attempt to recharge. For more
information on proper battery disposal, refer to
the battery manufacturer.
Why did the Mint system turn off when playing
my music extremely loud?
The Mint system may turn off to protect you and
the product from harm. If this happens, turn the
power button on the Mint amplifier to the "off"
position. Wait for 5 seconds and press the power
button on the Mint amplifier to the "on" position.
When I disconnect the USB cable from my
PC and reconnect it, the sound is not playing
through my Mint amplifier. What should I do?
Close Windows Media Player and reopen it. If the
sound still isn't playing through the Mint amplifier,
shut down your PC and restart.
Why is my Mint wireless Audio blinking red?
A blinking red light on the USB Audio transmitter
indicates that it needs to be paired manually:
1. Push and hold the wireless audio button on the
top of the Mint amplifier until it begins blinking
(about 3 seconds). Release the button. The
Mint amplifier is now ready to receive a pairing
signal and will continue blinking for 30 seconds.
If it does not receive a pairing signal within that
time it will stop blinking and return to its normal
operational mode.
2. As soon as you push the "connect" button(on
the button on top of the wireless USB audio
transmitter), it instantly sends a pairing signal
and pairing is complete. The light on the USB
audio transmitter will glow green.
ENGLISH 11