Functioning With Afnor Code - Gorgy Timing RADIO TIMING NETWORK TDF/DCF GPS AFNOR Modo De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

All manuals and user guides at all-guides.com
If the installation mode is activated before the issuer has been synchronized least
once, time will be transmitted to the time base of the issuer will operate autono-
mously and have started at 0H00.00s.

1.2.4. Functioning WITH AFNOR CODE

Make sure the transmitter is plugged on a 230VAC power supply source and that
the antenna is connected. Across the diode remains lit until receiving a valid signal.
Upon receipt of a valid signal LED flashes every 5 seconds indicating a radio show
takes place.
In the event of first installation you have the possibility of forcing the transmitter in
permanent emission by activating the switch number 7 in ON position. The red Led
in the front face will stay lighted in this mode.
ATTENTION this mode is reserved only for the installation to test all
the receiving clocks. This mode must be removed by repositioning
the switch 7 on OFF once the installation is finished. The LED in
front flashes again in normal mode.
Please note that when the installation mode is activated the transmitter does not
synchronize any more on AFNOR input.
If the installation mode is activated before the issuer has been synchronized least
once, time will be transmitted to the time base of the issuer will operate autono-
mously and have started at 0H00.00s.
MDE-RTnetwork-3076V1.2
1.
RADIO TIMING NETWORK TDF/DCF GPS AFNOR
19

Publicidad

Tabla de contenido
loading

Productos relacionados para Gorgy Timing RADIO TIMING NETWORK TDF/DCF GPS AFNOR

Tabla de contenido