Troubleshooting Guide - ELICA EBF52SS1 Manual Del Usuario

You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance does
not operate.
Appliance is not
cold enough.
Appliance turns
itself on and
off frequently.
The light does
not work.
Vibrations
The appliance
seems to
make too
much noise.
Display "E1",
"E2".
NOTE: This appliance is intended to be used exclusively for the storage and display of wines in
restaurants, hotels, bars and other commercial settings.
PROBLEMS WITH YOUR APPLIANCE

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE

The unit defrosts automatically in normal
operating conditions.

The appliance is turned off.

Tripped circuit breaker or a blown fuse.

The temperature is not set correctly.

The ambient temperature could require a
lower temperature setting.

The condenser is too dirty.

The ventilation opening is blocked or too
dusty.

The room temperature is higher than
average.

A large number of bottles has been added
to the unit.

Appliance is not connected to a power
supply.

Tripped circuit breaker or a blown fuse.

The light was switched off on the control
panel.

The appliance is not properly level.
The rattling noise may come from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and crackling noises.

The appliance is not properly level.

"E1" or "E2" indicates that the air
temperature sensor has failed.

Connect the appliance.

Switch on the appliance.

Switch on the circuit breaker or
replace the fuse.

Check the set temperature.

Set a lower temperature.

Clean the condenser when
necessary.

Clear the obstructions and wipe off
the dust.

Put the appliance in a cooler place.

Leave the appliance to work for a
while until the set temperature has
been reached.

Connect the appliance.

Switch on the circuit breaker or
replace the fuse.

Switch on the light.

Level
adjustable feet.

Level
adjustable feet.

Call for service.
13
REMEDY
the appliance with
the appliance with
the
the