Power Stroke PS21ESLM Manual De Instrucciones

SETTING BLADE HEIGHT
NOTE: These instructions replace the Setting Blade Height instructions
located on page 8 in your operator's manual.
SETTING BLADE HEIGHT
See Figure 8.
WARNING:
To reduce the risk of injury, user
must read and understand the
operator's manual for their lawn
mower and this instruction sheet.
When shipped, the wheels on the
mower are set to a low- cutting posi-
tion. Before using the mower for the
first time, raise the cutting position to
the height best suited for your lawn.
The average lawn should be between
1-1/2 in. to 2 in. during cool months
OWT INDUSTRIES, INC.
P.O. Box 35, Highway 8, Pickens, SC 29671 USA
1-877-617-3501
www.powerstroketools.com
991000879
3-4-16 (REV:01)
PS21ESLM
and between 2 in. and 3-1/4 in. during
hot months.
To adjust the blade height:
Remove start key.

To raise the blade height, grasp the

height adjustment lever and move
it toward the back of the mower.
For a higher blade setting, pull the
height adjustment lever out and
over the rear of the bracket on the
mower.
To lower the blade height, grasp the

height adjustment lever and move
it toward the front of the mower.
 Reinstall start key when you are
ready to mow.
Fig. 8
A
C
B
A - Height adjustment lever (levier de réglage de la hauteur, palanca de
ajuste de altura)
B - Lowest blade setting (le plus bas réglage de la lame, ajuste más
bajo de la hoja)
C - Highest blade setting (le plus haut réglage de la lame, ajustes de
cuchilla más alto)