Craftmade UC2000-1 Guia De Inicio Rapido

REMOTE FAN WALL CONTROL
W
ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
NOTE: The frequencies on your Receiver and Transmitter have been preset at
the factory. Before installing the Receiver, make sure the dip switches on
the Receiver are set to the same position on the Transmitter. (Fig. 1) The dip
switches on the Transmitter are located on one side of the control.
1. CONNECTING THE TRANSMITTER
Remove wall plate, disconnect and remove the toggle switch from wall junction box.
Using the wire nuts provided, make the electrical connections to the new
Transmitter unit as shown in figure 1.
If your outlet box has a ground wire (green or bare copper),
connect the wall transmitter's ground wire to it; otherwise
connect the wall transmitter's ground wire directly to one of
the screws from the outlet box.
Carefully tuck wire connections inside wall switch box. Secure Transmitter with the
two screws (provided). Attach wall plate over control unit with the two screws
previously removed (FIG 2).
2. OPERATING THE TRANSMITTER
This unit operates on a 12 volt battery (included)
a. HI, MED, and LOW buttons:
These three buttons are used to select the fan speed.
Press and release the button of the desired speed setting;
HI = Highest speed
MED = Medium speed
LOW = Lowest speed
b. LIGHT button: This button will turn the light on or off and will also control the
brightness setting. Press and release the button and the light will turn on or
cycle continuously between bright and dim settings as long as the button is
held down. The light key has auto resume, it will stay at the same brightness
as the last time it was turned off.
c. FAN OFF button: This button will turn the fan off.
d. This remote control unit is equipped with 16 code combinations, to prevent
possible interference from other remote units such as garage door openers,
car alarm or security systems. If your fan or light kit go on and off without
using your remote control, simply change the combination code in you
Transmitter and Receiver.
e. Memory function
When turning off fan or light by wall control, the fan speed and light settings
will be memorized and automatically recovered the next time the fan or light
is turned on.
3. TROUBLE SHOOTING GUIDE
Question: Fails to operate
Answer: Make sure all connections on Receiver and Transmitter are done correctly
and that there are no loose wired or wire connections. Make sure fan pull chain is
set to the highest speed. Make sure code switches on Receiver and Transmitter
are set to the same code.
CAUTION:
Ceiling Angle Shall Not Exceed 30 Degrees For Mounting Controller.
OCT 2006
All manuals and user guides at all-guides.com
E1
WARNING! HOOK UP "IN SERIES" ONLY
Do not connect to hot and common wire of electric circuit
ao switch will be damaged. Refer to diagram below
AC120V INPUT
WHITE
BLACK
BLACK
BLACK
BARE
FIG. 1
FIG. 2
FIG. 3
The installation of your remote control is complete, restore power to junction box.
MODEL: UC2000-1
BLUE
BLACK / RED
WHITE
GREEN
+ 12V