Publicidad
15W
1W
FUNCTIONS
INPUT
15W
1W
INPUT
1
2
INPUT POWER: 220-240VAC, 50-60Hz
FUSE: 250V F1.6A
SERIAL NO.:
POWER CONSUMPTION: 50W
12
1. INPUT CONNECTOR
Connect your guitar to this connector using a
6.3mm TS jack cable.
INPUT POWER: 220-240VAC, 50-60Hz
FUSE: 250V F1.6A
SERIAL NO.:
POWER CONSUMPTION: 50W
2. HIGH/LOW SWITCH
Switch between 1W (low) and 15W (high) power
output using this switch.
3. REVERB CONTROL
Adjust this dial to control the amount of reverb
is added to the output signal. Turning fully
anticlockwise will add no reverb to the output
signal.
4. TREBLE CONTROL
Adjust this dial to control the amount of treble
(high frequency) sent to the speaker output.
5. MIDDLE CONTROL
Adjust this dial to control the amount of mid-
range frequency sent to the speaker output.
6. BASS CONTROL
Adjust this dial to control the amount of bass (low
frequency) sent to the speaker output.
7. TONE CONTROL
Adjust the tone of your amplifier using this dial.
Fully anticlockwise will produce a thinner sound,
fully clockwise will produce a broader sound.
8. VOLUME CONTROL
Adjust this dial to control the overall volume sent
to the speaker output connector on the rear of the
amplifier.
9. GAIN CONTROL
Adjust this dial to increase the input gain from
the guitar. More gain will create a more distorted
sound.
REVERB
TREBLE
MIDDLE
REVERB
TREBLE
MIDDLE
3
4
5
MADE IN CHINA
REVERB
FOOTSWITCH
13
MADE IN CHINA
REVERB
FOOTSWITCH
0
BASS
TONE
VOLUME
0
BASS
TONE
VOLUME
6
7
8
RETURN
RETURN
SEND
SEND
EFFECTS LOOP
14
15
10. STANDBY LIGHT
RETURN
RETURN
SEND
SEND
This light will illuminate when the amplifier is
switched on.
EFFECTS LOOP
11. POWER SWITCH
This switch turns the amplifier on and off. When
the amplifier is switched on, allow a moment for
the tubes to warm up before playing. This will
increase the lifespan of the tubes and create a
better output sound.
12. MAINS POWER CONNECTOR
Connect the amplifier to the mains power
using this connector. Only use the mains cable
provided with the product.
13. REVERB FOOTSWITCH CONNECTOR
Connect a one button footswitch with a 6.3mm
TS jack cable to this connector (not included) to
turn the reverb on and off remotely.
14. EFFECTS LOOP (RETURN) CONNECTOR
Connect the output of an external effects
processor to this connector using a 6.3mm TS
jack cable.
15. EFFECTS LOOP (SEND) CONNECTOR
Connect the input of an external effects
processor to this connector using a 6.3mm TS
jack cable.
16. SPEAKER OUT CONNECTOR
Connect an external speaker to this connector
using a 6.3 TS speaker jack cable.
NOTE: This connection outputs at an amplifier level.
It is recommended to use a speaker jack cable
capable of carrying the required load.
3
15VR
GAIN
STANDBY
15VR
STANDBY
GAIN
9
10
11
8-16
SPEAKER
OUTPUT
16
8-16
SPEAKER
OUTPUT
Publicidad
