Sleep Function - Sytech SY-1029R Manual Del Usuario

SNOOZE/LIGHT FUNCTION
During the wakeup time, press the SNOOZE/LIGHT button once to temporarily turn off the alarm.
After approximately 9 minutes the alarm will sound again. The cycle will repeat when the SNOOZE /
LIGHT button is pressed again. Alarm max last for 1 hour
Note:
When pressing the SNOOZE / LIGHT button, the panel backlight will turn on, and will turn off
automatically after 1 minute.
Press and hold SNOOZE/LIGHT for backlight always ON, then press and hold again for back to
normal

SLEEP FUNCTION

The sleep function is used for automatic switch-off of the Radio
In Radio Mode, press the SLEEP button to set the sleep time in minutes (90 > 60 > 30 > 15 > 0). The
radio will now play and switch off automatically when reach the sleep time.
SPECIFICATIONS
Radio Frequency : FM – 87.5 – 108MHz
Antenna : External Antenna Wire
Output : 500mW Max.
Speaker : 50mm, 8ohm x 1
Power Required : Input 230v 50Hz
Clock backup – DC3V, 1 x CR2032 battery (battery included)
While every effort has been made to ensure all information contained in this manual is correct, design
and specifications are subject to change without notice.
All manuals and user guides at all-guides.com
E-4