Technical Characteristics - Chicco Turbo Touch Manual De Instrucciones

All manuals and user guides at all-guides.com
GB USA
Instruction Manual
Age: From 2 years +
Please read these instructions carefully before use and keep them for future reference.
This car requires 3 x 1.5 Volt, "AA" alkaline type batteries. The batteries are included.
WARNING!
For your Child's Safety:
Before use remove and dispose of any plastic bags and any other packaging (e.g. fasteners, fixing ties, etc.)
and keep them out of reach of children.
WARNINGS
• Check the toy regularly for signs of wear and damage. Should any part be damaged, do not use and keep
out of reach of children.
Warning!
• Do not touch the wheels of the toy when in movement.
• Do not use the toy on the road.
• Do not use the toy on wet, sandy, or dusty surfaces.
• Do not leave the toy close to heat sources.
• The maximum distance the toy can travel is approximately 10 metres (this could be further reduced due
to environmental conditions).

TECHNICAL CHARACTERISTICS

Diag. A
On/off switch lever (I / O); Battery compartment cover.
Diag. B
Battery recharge system.
INTRODUCTION
This toy is an electric powered car that can be easily activated by "pressing" the car itself. The more the car is
pressed on the ground, the greater the distance the car will cover.
HOW TO USE THE TOY
• Switch on the toy by positioning the ON/OFF switch lever (diag. A-1), located under the car, on I.
• The car is charged by pressing it downwards several times (diag. B).
• When the car has been charged, it starts to travel at speed in a straight line. The more times the car is
pressed, the greater will be the distance that the car can cover.
• After use, the car should always be switched off by positioning the sliding switch (diag. A-1) on O.
WARNING: The "Try Me" position shown on the switch must only be used for demonstration purposes at the
sale point. Do not use the toy in this mode, as it will limit its function.
FITTING AND/OR REPLACING BATTERIES
• Batteries must only be fitted by an adult.
• To replace spent batteries: Loosen the screw on the battery compartment cover (diag. A-2) with a screw-
driver and open the cover. Then remove the spent batteries and fit new ones, ensuring that they have been
fitted in the correct polarity (as shown on the product), close the battery cover, and tighten the screw.
• Only use alkaline batteries of the same type or equivalent to the type recommended for the correct func-
tion of this product.
• Never mix new and old or different types of batteries.
• Always keep batteries and tools out of reach of children.
• Do not short-circuit the battery terminals.
TurboTouch
8
• Alw
• Al
• Re
• Do
fer
• In
to
• Do
• Th
• If
ca
• Th
the
and
ute
serv
Thi
you
prin
Cd=
The
can
trea
and
disp
serv
CA
• Cl
• Pr
AR
prio
part
Mad