Safco 1902 Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
Sort and count your parts!
PARTS LIST
LETTER
DESCRIPTION
CODE
A
Top Panel
B
Bottom Panel
C
Screw Post
D
Left Side Panel
E
Back Panel
F
Right Side Panel
G
Locking Cam
H
Left Cabinet Rail
I
Small Screw
J
Right Cabinet Rail
K
Caster without Brake
L
Large Screw
M
Caster with Brake
N
Left Shelf Rail
O
Right Shelf Rail
P
Shelf
TOOLS REQUIRED: Phillips Screwdriver
Properly identify the
four types of rails
used!
The Cabinet Rails (H,
J) have C-shaped
cross sections; rollers
are at the FRONT, and
the Left Cabinet Rail is
stamped "CL" near the
roller, while the Right
Cabinet Rail is
stamped "CR".
The Shelf Rails (N, O)
have Z-shaped sec-
tions; rollers are at the
BACK, and they are
stamped "DR" for
Right and "DL" for Left.
2
Lay out the D Left Side Panel, the E Back Panel,
and the F Right Side Panel with the holes facing up.
Insert three G Locking Cams into the large holes at
the top of each Side Panel with the arrows pointing
toward the OUTER edge, and three more into the
holes at the bottom edges. Insert four Locking Cams
into the holes in the Back Panel.
On the Left Side Panel, install a H Left Cabinet Rail
(C-shaped end), using three I Small Screws each,
into the set of holes near the top of the Side Panel,
making sure that the rollers are facing the
FRONT of the Panel and using the
hole CLOSEST to the roller.
Do the same with the Right Side Panel,
using the J Right Cabinet Rail.
Screw two C Screw Posts into the
remaining holes near the back edge of
each Side Panel.
1902-37: 1 of 2; Rev. 2; 1/04
All manuals and user guides at all-guides.com
Desk Side Mini Workstation
QTY. PART NO.
1 1902-01
1 1902-05
16 HFFMFB
1 1902-02
1 1902-04
1 1902-03
16 HFFMFC
1 1902-15
12 1902-23
1 1902-16
2 8918-25
16 8918-22
2 8918-24
1 1902-17
1 1902-18
1 1902-06
USE THIS HOLE
FOR FRONT
J
SCREW
H
N
ROLLER
H
Safco Products Company, New Hope, MN 55428
A
P
G
D
C
E
For questions or concerns, please call
Safco Consumer Hot Line 1-800-664-0042
available Monday-Friday 8:00 AM to 4:30 PM (Central Time)
(English-speaking operators)
1
Work on a smooth, clean surface.
Locate the A Top Panel and B Bottom Panel and
position them with the six holes up. Insert six C
Screw Posts into the holes, and tighten with a screw-
driver (do not overtighten!)
A
O
I
D
MODEL
NUMBER
I
C
F
O
N
H
B
K
M
ASSEMBLED UNIT
L
MODEL 1902
C
ROLLER
G
J
E
C
1902
J
B
F