Jumper Settings - LanParty BLOOD-IRON P45 Elite Serie Manual Del Usuario

E
English
Chapter 2 - Hardware Installation

Jumper Settings

Clear CMOS Data
1-2 On: Normal
(default)
2-3 On:
Clear CMOS Data
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
c) The overclocked settings in the BIOS resulted to the system's instability or
caused system boot up problems.
you can reconfigure the system with the default values stored in the ROM BIOS.
JP8 is accessible from the rear panel of the system. This provides convenience by
allowing you to clear the CMOS without having to remove the chassis cover.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system then unplug the power cord.
2. Set JP2/JP8 pins 2 and 3 to On. Wait for a few seconds and set JP2/JP8 back
to its default setting, pins 1 and 2 On.
3. Now plug the power cord then power-on the system.
10
All manuals and user guides at all-guides.com
3
JP8
2
1
3
2
1
C217
1 2
1-2 On: Normal
(default)
1 2
JP2
2-3 On:
Clear CMOS Data
3
3