GEIGER GF0.10 Manual De Instrucciones

Operating Instructions GF0.10
The hand-held transmitter GF0.10 has been specially designed for the operation of one or several simultaneously
moving awnings (retracting enabled via key
The control keys
sun-automatic (
The required coding is realised by means of the coding switch (DIP switch) that exists inside the hand-held
transmitter.
In the event the LED doesn't light up if actuating one of the control keys, the battery needs to be replaced.
Battery: 12 V, type A23. The following battery types can be used for replacement: 23A, VA23A, MS21 or MN21.
Spent batteries must be disposed of in compliance with the relevant national rules currently operative and in force.
Transmit frequency: 433.92 MHz
der
den To make a code setting or to replace the battery, please loosen the crosshead screws (Phillips screws) that exist at
in. the bottom of the hand-held transmitter by means of a cross-slot screwdriver (size PZ 0, ISO 8764) and separate
the two half-shells from each other. Use the DIP switches No. 1 to 6 in order to set the desired personal coding.
The transmitter complies with the relevant technical regulations enacted by the European Community. It bears the
m
CE mark and is authorised for use in all EU member states and in Switzerland without any need of prior registra-
tion. To learn more about the EC Declaration of Conformity pertaining to this hand-held transmitter, please visit our
website at: www.geiger-antriebstechnik.de.
Gerhard Geiger GmbH & Co. KG • Schleifmühle 6 • D-74321 Bietigheim-Bissingen • Telephone +49 (0) 71 42/9 38-0
de Fax +49 (0) 71 42/9 38-230 • info@geiger-antriebstechnik.de • www.geiger-antriebstechnik.de
All manuals and user guides at all-guides.com
and have been equipped with a special function for the activation or deactivation of the
= sun-automatic "OFF",
a. E xtending
b. R etracting
c. S un-automatic "ON"
d. S un-automatic "OFF"
1 2
+
0
-
Individual coding
, extending via key ).
= sun-automatic "ON").
3 4 5 6 7 8
Allocation of
sensor signal
9