Operating Instructions; Applying Power; Listening To The Radio - riptunes RAFP-110 Manual De Usuario

All manuals and user guides at all-guides.com

OPERATING INSTRUCTIONS

POWER OPERATION

Applying Power

Your FM/AM receiver runs only on AC power, using 2 x AAA bat-
teries.
To run on battery power:
1. Open the battery door on the rear of the unit.
2. Insert 2 x AAA size batteries (not included) into the battery
compartment. Follow the diagram in the battery compart-
ment to ensure that the batteries are facing the correct direc-
tion.
3. Slide the battery door back into place.

LISTENING TO THE RADIO

Tuning to a Station
1. Turn the volume control (6) up to turn on the receiver.
2. Select the desired radio band with the band switch (2).
3. If an FM station is desired, extend the telescopic antenna (3) for
optimal reception.
Note: AM stations are tuned with an internal ferrite antenna and do not
require the telescopic antenna. The AM antenna can be adjusted by
rotating the receiver unit itself.
4. Tune in the desired station by adjusting the tuning control (7)
and looking at the dial scale (5).
5. Adjust the volume again as needed. If desired, connect head-
phones or earbuds to the headphone jack (1).
7