Environmental Protection - Worx MAKER X WA7160 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ASSEMBLY
1. Insert battery pack into the hub. (See Fig. A)
2. Connect the hub and MakerX series tools. (See Fig. B)
WARNING: Before operation, make sure the speed control button on the
hub is at the"Min" position. (See Fig. C)
OPERATION
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip.Press
the on/off switch to start. (See Fig. D)
2. Adjust the variable speed as needed for the tool and application.
3. Press the on/off switch on the hub to turn off after use.
NOTE: For sake of safety, disconnect from the hub and adjust the speed control to
"Min" position once completing the operation.
4. With a USB port (output: 5 V, 2 A) (only for specific models), your hub can be
connected to a LED light, or used to charge small electronics or tools such as cell
phones, cordless screwdrivers, tablets, etc.. (See Fig. E)
MAINTENANCE
There are no repairable parts in your hub.
For adjustment, repair or maintenance, please leave it to the professional. Do not try
to repair the hub yourself.
Your hub does not need to be lubricated or otherwise maintained. Don't clean the
hub with water or chemical cleaning agent, just wipe it with a dry cloth. Store in a dry
environment.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or
retailer for recycling advice.
EN
9