Set Start Mode; Set Pulse And Pause Interval; Real-Time Overview; Meaning Leds - TechGrow Interval Pro Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Pause Unit
Seconds
Turn the PTK to select the desired time unit for the
pause time: seconds, minutes, hours or days.
Press the PTK to confirm.
You enter the next screen.

2.4 Set start mode

The fourth screen of the main menu appears:
Start cycle with
Pulse
Turn the PTK to select the desired start mode: pulse or
pause.
Press the PTK to confirm.
You return to the main screen.

3. Set pulse and pause interval

You are in the main screen:
Pulse 1 seconds
Pause 0:00:00:00
Press the PTK once.
When the Interval Timer Pro starts in pulse mode and
the selected time unit is "seconds", the next screen
appears:
Set Pulse time
00 Seconds
Turn the PTK to set the desired value (1 – 99).
Press the PTK to confirm.
____________________________________________________________________________________________________________________________
TechGrow
| Innovative Growing Solutions
You enter the next screen (for example if the time unit
for pause time is "hours"):
Set Pause time
00 Hours
Turn the PTK to set the desired value (1 – 99).
Press the PTK to confirm.
You return to the main screen.

4. Real-time overview

Pause 2 hours
Pulse 0:00:29:54
The main screen displays the current data.
Line 1: the settings of pause and pulse time are
displayed alternately.
Line 2: the data of the current mode are displayed. In
this example the pulse mode, which still lasts 29
minutes and 54 seconds. The green LED is on.
After this period of time, the pause mode is
activated for 2 hours. Then, the red LED comes
on.

5. Meaning leds

The Interval Timer Pro has two LEDs:
Green: pulse mode is active.
Red: pause mode is active.

6. Fuse replacement

In the event of overload or short circuit, the internal
fuse of the Interval Timer Pro will break. To replace the
fuse you have to open the Interval Timer Pro. Go
through the following steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Interval Timer Pro.
3. Locate the fuse and remove it.
4. Insert a new 10 amp fuse.
5. Screw the 4 screws to close the housing.
6. Your Interval Timer Pro is ready for use again.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido