Charging Methods; Dc Charging Adapter - Wagan Tech LITHIUM CUBE 1200 Manual De Usuario

CHARGING METHODS

Factory supplied equipment allows the Lithium Cube to be charged using:
AC Charging Adapter
Charge times
• AC charger: about 8-12 hours
• DC charger: about 12-16 hours
• Solar panels: about 14 hours (depending on weather)
AC Charging Adapter
The Lithium Cube is supplied with a fully automatic AC charging adapter. To charge the Lithium
Cube using the AC Charging Adapter:
1. Connect the AC charging adapter to an AC wall socket.
2. Insert the charger's DC plug into the Lithium Cube's DC input socket.
3. Charging is complete when the light on the battery status reaches 100% and stops
flashing.
4. After charging the battery, disconnect the adapter from the AC wall socket first, then
from the device.
5. The Lithium Cube will shutoff automatically when not in use.

DC Charging Adapter

The DC charging adapter is a cord with a fused DC accessory plug, fused at 10 amps to prevent
damage if there is an inadvertent short. Refer to the maintenance section to replace a fuse if
necessary.
To charge the Lithium Cube using the DC Charging Adapter:
ONLY USE THE DC CHARGING ADAPTER SUPPLIED WITH THIS UNIT. DO NOT CONTINUOUSLY CHARGE FOR MORE THAN
16 HOURS USING THE DC TO DC METHOD.
1. Note that the engine must be running while charging the Solar Lithium Cube to avoid
discharging the vehicle's battery.
Wagan Tech and wagan.com are trademarks of Wagan Corporation
User's Manual—Read before using this equipment
DC Charging Adapter
(Charging from your
vehicle as you drive)
© 2021 Wagan Corporation. All Rights Reserved
Solar Panels
(not included)
5