Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Lay out the jumping mat in the center of the frame. The slide a suspension cord from left to right
through the nylon loop as shown in picture
•
Use your right hand to stretch the loop end of the cord OVER the top rail and your left hand to pull
the "closed" end of cord UNDER the top rail, then pass the closed end through the loop as shown in
picture .
•
SLOWLY release the loop end of the cord so that it tightens around the closed end,locking the suspen-
sion cord in place,. As shown.
•
From the 1st attached cord . count around the jumping mat to the 16th loop and repeat steps 8~10
st attaching the 2nd cord dicectly across from the 1st . As shown above.
•
Next ,count back around the jumping mat 8 loops and repeat steps 8~10 attaching the 3rd cord
about half way between the 1st and 2nd codes .
•
Then from the 3rd attached cord,count around the jumping mat 16 loops and repeat 8-10 to attach
the 4th cord,the number on picture 12 show the approximate position of the first 8 suspension cords,
continue connecting the remaining cords as shown in step 8~10 ,but always connect a cord,and then
switch to the opposite side of the trampoline to connect the next cord.
•
Lay the pad cover. AirZone printed side up over the suspension cords. Carefully position each of the
6 openings in the pad cover over their corresponding enclosure pole socket, as shown.
•
Carefully work the lower mesh skirt (attached to the pad cover) down, around the entire perimeter
of the trampoline, on the outside of the legs.
•
Align the grommet attached to the bottom of the lower mesh skirt with the hole near the base of the
leg and secure with screw. DO NOT OVER-TIGHTEN.
•
Repeat Step 9 with the remaining 5gromments in the lower mesh skirt and their corresponding legs.
All manuals and user guides at all-guides.com
12
Publicidad
Tabla de contenido
