Problems Solution - Lacor 69314 Instrucciones De Uso Y Mantenimiento

3- Clean the ice container, the water tank and evaporator frequently Use a mixture of water and
vinegar to obtain the best results.
4- Extended lack of use can cause the introduction of air in the pump circuit. The insufficient
water indicator may come on. Switching the machine on and off will resolve it.
5- Only use original parts, the use of parts supplied by the manufacturer can permanently damage
the machine.
6- In the case of not using the device for a long period, store it in a dry, well-ventilated place free
from humidity.
Problem
The compressor works with
a different sound than usual.
Indicator of insufficient water
level comes on.
The "ON" button does not
light.
The ice-cubes stick together.
The conditions for making
ice are correct but ice is not
made.
The indicators of insufficient
water and ice container full
come on simultaneously.
PROBLEMS SOLUTIONS
Possible Cause
The voltage is less than that
recommended.
1. There is no water
2. The pump circuit is full of
air.
Fuse burnt / Plug not con-
nected.
The water and room tem-
perature is very low.
Cooling agent leak / Blocked
sealing system.
The water tray is blocked by
the ice-cubes.
Solution
Stop the machine and do not
switch it on until making sure
of having adequate voltage.
1. Switch the machine off, fill
the water tank, wait for 3
minutes and switch it on
again.
2. Open the bleed valve and
drain some water.
Replace the fuse / Connect
the machine.
Switch the machine off and
re-start the ice-cube making
cycle.
Call the technical assis-
tance.
Switch the machine off,
clean the water tray and
switch it on again.
26