THOMSON HT220 Manual Del Usuario página 22

USE
It is recommended to enable the Pro Logic II function when
you play a DVD, and to disable it again when playing an
audio CD, VDC or a data disk.
• Pro Logic II
Start/Stop/Auto
Mode: Pro Logic mode selection: Music, Films, Pro
Logic or Auto.
Panoramic: Enables reproduction of the same sound
parameters on the rear and front speakers.
setting modes.
Center Width: Allows distribution of left and right
speakers sound through the center channel, for a
better merged sound output. Setting is achieved
gradually on 8 positions.
Note: Panoramic, Dimension and Center Width are available
in music mode only. These options enable customization of
Pro Logic II.
There are several modes available: Concert, Hall, Room,
Bathroom, Cave, Stadium or Church.
Mono output: Stereo (stereo signal), L-Mono (left channel
signal), R-Mono (right channel signal), Mix-Mono (mixed
signal).
(linear compression rate): Stop, 1/8, 1/4, 3/8, 1/2,
5/8, 3/4, 7/8 and Total.
EN 20
HOME CINEMA
HT220
Component:
• Component can be set to S-Video, YUV or RGB.
Resolution:
HDMI output mode selection: 480i, 480P (720), 720p60,
1080i60, 1080p (60Hz), 576i, 576p (720), 720p50, 1080i50,
1080p (50Hz).
• Sharpness.
• Brightness.
• Contrast.
• Gamma.
• Hue.
• Saturation.
• Luma delay.
HDMI Setup:
• HDMI output On/Off modes.
• Deep_Color setting.
Video Standard: PAL, Multi, NTSC.
Audio
Selection of DVD playback audio language (8 languages
available).
Subtitles
Selection of DVD playback subtitle language (7 languages
available).