Safety Cap - Crena CY658 Manual De Instrucciones

·Never direct the jet of steam towards small particles of
debris without first protecting the human eyes.
·Never direct the jet steam towards any human bodies as
the heat of the steam could burn the skins.
SPECIAL INSTRUCTION FOR USE
·Iron only on heat resistant surfaces and on surfaces that
allow the steam to escape e.g. mesh ironing boards.
·Ensure the safety cap is fully and correctly screwed on,
otherwise you may experience steam escaping from around
the cap.
·The indicator light of steam may go on and off from time to
time during use of the Steam Iron. This indicates the
machine maintaining the correct and constant pressure and
is quite normal.
WATER MARK
Before leaving the factory, each product will under
rigorously live test. Water mark may find in boiler or steam
monotube.

SAFETY CAP

The steam station is equipped with safety cap, which
prevents children from getting hurts from hot steam if there
is still pressure remaining inside the tank. This is an
important and indispensable safety device, and it necessary
to follow certain procedures when re-filling the tank.
When you have used up all the water in the tank, do as
follows:
1-Switch off the on/off switch
2-Press the steam button on the iron so as to fully exhaust
the steam supply from the tank.
3-Disconnected the power supply cable from the mains.
4-Press and at the same time unscrew anti-clockwise the
safety cap.
5-Wait for a few minutes to allow the generator tank to cool
down-