Audio Description
(not available in all locations)
(digital channels only)
This function handles the Audio Stream for
the AD (Audio Description) which is sent along
with the Main audio from the broadcaster.
Audio Description (Off / On)
■
audio description function on or off.
Volume
: Adjust the audio description volume.
■
Auto Volume (Off / Normal / Night)
To equalize the volume level on each channel, set to Normal.
Night
: This mode provides an improved sound
■
experience compared to Normal mode, making almost
no noise. It is useful at night.
Speaker Select (External speaker /
TV speaker)
A sound echo may occur due to a difference in decoding
speed between the main speaker and the audio receiver. In
this case, set the TV to External Speaker.
✎
When
Speaker Select is set to External Speaker, the
volume and
MUTE
buttons will not operate and the
sound settings will be limited.
✎
When
Speaker Select is set to External Speaker, you
should use these settings.
x
TV
Speaker: Off , External Speaker: On
✎
When
Speaker Select is set to TV Speaker, you
should use these settings.
x
TV
Speaker: On , External Speaker: On
✎
If there is no video signal, both speakers will be mute.
Additional Setting
(digital channels only)
DTV Audio Level (MPEG / HE-AAC)
■
allows you to reduce the disparity of a voice signal
(which is one of the signals received during a digital TV
broadcast) to a desired level.
✎
According to the type of broadcast signal,
/ HE-AAC can be adjusted between -10dB and
0dB.
✎
To increase or decrease the volume, adjust
between the range 0 and -10 respectively.
All manuals and user guides at all-guides.com
: Turn the
: This function
MPEG
SPDIF Output
: SPDIF (Sony Philips Digital InterFace)
■
is used to provide digital sound, reducing interference
going to speakers and various digital devices such as a
DVD player.
Audio Format: During the reception of a digital TV
broadcast, you can select the Digital Audio output
(SPDIF) format from the options PCM or Dolby Digital.
✎
By connecting to 5.1ch speakers in a Dolby
Digital setup, maximize your interactive 3D sound
experience.
Audio Delay: Correct audio-video mismatch, when
watching TV or video, and listening to digital audio
output using an external device such as an AV receiver.
Dolby Digital Comp (Line / RF)
■
signal disparity between a dolby digital signal and a
voice signal (i.e. MPEG Audio, HE-AAC, ATV Sound).
✎
Select
Line to obtain dynamic sound, and RF
to reduce the difference between loud and soft
sounds at night time.
Line: Set the output level for signals greater or less than
-31dB (reference) to either -20dB or -31dB.
RF: Set the output level for signals greater or less than
-20dB (reference) to either -10dB or -20dB.
Sound Reset (OK / Cancel)
Reset all sound settings to the factory defaults.
¦
Selecting the Sound Mode
When you set to Dual l-ll, the current
sound mode is displayed on the screen.
Audio
Dual I-II
Type
Mono
A2
Stereo
Stereo ↔ Mono
Stereo
Dual
Dual I ↔ Dual II
Mono
NICAM
Stereo
Mono ↔ Stereo
Stereo
Mono → Dual I
Dual
Dual II
✎
If the stereo signal is weak and an automatic switching,
occurs, then switch to the mono.
✎
Only activated in stereo sound signal.
✎
Only available when the
Input source is set to TV.
: This function minimizes
Default
Mono
Automatic
change
Dual I
Mono
Automatic
change
Dual I
17
English