Wireless Router Mode; Wan Settings; Wireless Settings - Mach Power WL-APDB733P48-077 Manual Del Usuario

3.2 Wireless router mode (If supported)
The WAN port of the AP will be connected directly to the MODEM. Start the DHCP service of the AP.
• Select the network connection mode: select the type of Internet service to which you have subscri-
bed with the ISP (DHCP, Static, PPPoE).
• Configure the external network: DHCP: IP, subnet and Gateway will be assigned automatically by
your ISP. Static IP: Enter the IP, subnet and gateway information provided by your ISP. PPPoE: Enter
the ID and password provided by your ISP.
• Configure the wireless network: Change the SSID name and encryption mode and go to "Wireless
Settings" to change the detailed configuration.
• Confirm that the setup is complete.
Note: When wireless routing mode is selected, the IP address of the AP will be changed to 192.168.11.1
and the DHCP service will be enabled.
4

WAN settings

Configure the AP to connect to the WAN: DHCP, static IP, PPPoE are supported.
Note: If you have previously followed the configuration process using the wizard, you do not need to
configure these options again.
5

Wireless settings

Configure the 2.4GHz and 5GHz wireless settings by entering SSID and encryption methods. Note:
If you have previously followed the configuration process using the wizard, you do not need to
configure these options again. If you need more SSIDs, you can go to the "Advanced" tab and set the
additional SSID names.
6