Audiovox Professional Serie El Manual Del Propietario página 5

All manuals and user guides at all-guides.com
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on and off
using the valet toggle switch. To do this....
1. The valet switch must be in the "off" position.
2. Turn the ignition key on, and then off.
3. Within 10 seconds of turning the ignition key off, move the valet toggle switch to on
- off - on - off - on - then off.
4a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps to
indicate that the chirps have been turned off.
4b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp to
indicate that the chirps have been turned on.
5. Whenever power to the system is disconnected (for repair or service of the vehicle),
the chirps will be active when the power is re-connected. To turn the chirps off, simply
execute steps 1 through 3 above.
NOTE: Whenever the chirps are by-passed, the 3 chirp defective zone and the 4 chirp
intrusion indicator will always operate. This feature will always warn you if a zone is
active during arming or the vehicle was tampered with in your absence, even if the
normal arming and disarming chirps have been turned off.
REMOTE PANIC OPERATION (CHANNEL 1):
The arming button on your keychain transmitter also functions as a "panic" switch for
instant activation of the alarm in emergency situations. To use the remote panic switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or more.
The alarm will immediately sound.
2. To stop the alarm, press and release the arming button on the keychain transmitter.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
WARNING! Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required is
a light push to the button.
Page 5