Cleaning, Care & Maintenance - Polar CD229 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
The control panel is located below the doors on the
rear of the appliance.
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Press the
button to turn the light On or Off
as required.
4
CD229-CD230_ML_A5_v6_20211130.indb 4
CD229-CD230_ML_A5_v6_20211130.indb 4
Setting the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
or
buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the
button for 6 seconds to begin
automatic defrost. The defrost light illuminates.
Cleaning, Care &
Maintenance
1. Switch off and disconnect from the power
supply before cleaning.
2. The doors can be removed for ease of
cleaning.
3. Clean the interior of the appliance as often as
possible.
4. Do not use abrasive cleaning agents. These
can leave harmful residues.
5. Clean the door seal with warm soapy water.
6. Always wipe dry after cleaning.
Condensation will form in refrigeration with
frequent opening of the doors and on hot humid
days, please ensure condensation is allowed to
drain properly or is wiped dry.
Replacing the Interior Lamp
Call your POLAR dealer or a qualified electrician,
the Lamp Assembly is available to purchase as a
spare part.
Cleaning the Condenser
Periodically cleaning the condenser can extend
the life of the appliance. POLAR recommend that
a POLAR agent or qualified technician clean the
condenser.
2021/11/30 15:46
2021/11/30 15:46

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cd230

Tabla de contenido