Clearing Values From Memory; Time Adjustment - TechLine Z-40 Manual De Instrucciones

2. To read memory values from a selected Memory Zone, use the "User-Switching Key" to
select a Memory Zone (1 or 2) from which you want to recall values from. Then, press the "M"
key, and the values will be shown on the LCD display with an assigned memory sequence
number.
3. The monitor will display an average of the previous measurements first.
Every new press of the "M" key calls for one set of prior values stored. Latest memory will be
recalled first. The calculated average will be applied to a maximum of the last 3 memories.

Clearing Values from Memory

1. Press the User-Switching key to select memory zone 1 or memory zone 2.
2. Continue to press the "M" key for approximately 5 seconds, then the data in the pre-
designated memory zone can be erased automatically.
Note:
The data as both memory zones (zone 1 and zone 2) can be erased if any of the batteries
is moved away from the socket. (Suggest the users to first record the data before replace or
move away the batteries.)

Time Adjustment

1. To adjust the date/time in the monitor, press the
number showing the month.
2. Change the month by pressing the "
one in a cycling manner. Press the
show a blinking number representing the date.
All manuals and user guides at all-guides.com
" key. Each press will increase the number by
key again to confirm the entry, and the screen will
key. The display will show a blinking