All manuals and user guides at all-guides.com
Fax +39 030 9904733
OPERATION (see figures)
Warning: always remove the plug from the outlet before any assembly operation, reassembling and
cleaning.
Before each use, check that the appliance is in good working order, and that the cable is not damaged: if
the power cable is damaged, it must be replaced by the manufacturer or its technical services department
or someone with a similar qualification in order to prevent any risks.
1)
Position the container (6) on the non-slip mat (7).
2)
Slide the blades (5), onto the shaft, taking care not to cut yourself.
3)
Place the food to be chopped in the container.
4)
Place the cover (4) on the container.
5)
Place the motor body (3) on the container.
Attention: the appliance have one safety system that prevents operation if the motor body isn't
correctly positioned and locked.
6)
Put the plug into the mains socket.
7)
During use, it is necessary to hold the container with the ingredients firmly.
8)
The motor body is equipped with two pressure switches speeds (max "1" and min. "2"): press the
speed desiderate to operate the engine and vice versa release it to turn it off.
9)
The appliance cannot operate continuously for more than 15 seconds. After this time, you must wait
for at least 1 minute before using it again. If you do not do this, the appliance may not work properly
again. Failure to do this may affect the performance of the appliance. It is recommended to use the
appliance for short on / off periods: this will improve the preparation of food, and this ensures a
longer life of the engine. The times for preparing various foods are indicated in the following table.
10) If the blades get blocked, disconnect the appliance from the mains and remove the ingredients that
are blocking the blades.
11) When you having finished using the blend: release the switch, wait for the blades to come to a
complete stop and remove the plug from the socket.
If the appliance is not in use for long periods of time, remove the plug from the plug point.
Practical tips
For fine, uniform chopping, cut solid foods into small pieces before putting them in the container; in some
cases (such as parsley) it is a good idea to stop every so often to mix the food and then continue chopping.
CLEANING AND MAINTENANCE
Warning: before cleaning the appliance, turn it off and unplug it from the mains. The appliance and all
the parts which come in contact with food (container, cover and shaft with blades) require careful
cleaning after each use.
• To clean the container, cover and shaft and blades (the blades are sharp: be careful), use a soft
sponge with warm water and household washing up liquid. Then rinse with plenty of water under a
running tap, and dry thoroughly. Do not use steel wool or abrasive products. The shaft with blades
can be washed in the dishwasher.
• Engine body: must only be cleaned with a soft cloth that has been slightly dampened either with just
water and/or detergent. It cannot be washed in the dishwasher or even under the running water: if
the electrical parts (including cable and plug) get wet, dry them thoroughly and completely before
use.
• When the appliance is not in use, place it in a dry place.
• If you decide to no longer use the appliance, we recommend making inoperative by cutting off the
power supply cord (after first making sure that the plug is removed from the mains socket) and make
any parts possibly used as toys harmless (blade).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in order
to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language integrity.
11/16
Assembly page 11/32