Skil 3300MS Instrucciones De Funcionamiento Y Seguridad página 7

SM_2610957116_05-08 6/5/08
PERPARING SAW MOUNTING BRACKETS
See Figure 4.
Place a sliding mounting plate (1) onto each of four
5/16 in. x 2 in. carriage bolts (2) and feed bolts into
both mounting brackets (3) as shown in figure 4.
ATTACHING SAW TO
SAW MOUNTING BRACKETS
See Figure 5.
Always position the saw to achieve maximum balance
and stability. All four corners of the saw must be bolted
to the mounting brackets before use. Make sure bolts
do not extend above the table of the miter saw.
If the saw has four holes that line up with the slots
in the saw mounting brackets:
1. Unplug the saw and lock the saw arm in the down
position.
2. Lift one side of the saw and place a saw mounting
bracket underneath, aligning the carriage bolts with
the miter saw mounting holes, as shown in figure 5.
3. Lower the saw down onto the bracket, feeding the
carriage bolts through the mounting holes.
4. Secure in place using a flat washer (4), lock washer
(5), and nut (6).
5. Repeat steps 1 through 4 to install second bracket to
the other side of the saw.
6. After making sure both brackets are parallel to each
other, finger tighten all four nuts to hold in position.
7:44 AM Page 7
Assembly
3
1
2
FIG. 5
6
5
4
7
FIG. 4