HIGHONE DAV 7 C W566C Instrucciones De Uso página 8

C
Useful information
Troubleshooting
Problem
Power outage.
The plug is not correctly
connected.
The appliance will not start.
The laundry load is too
heavy.
The thermal circuit
breaker has tripped.
The filter is soiled.
The appliance emits heat or
a burning smell.
The air inlet or outlet is
dirty.
Too much laundry is being
loaded.
The laundry is not taken
out of the machine quickly.
Laundry is too dry.
The clothes were not
sorted properly.
The temperature is too
high.
12
Cause Solution
Wait until the power is
restored.
Check the plug and make
sure the connection is
correct.
Laundry placed in the
dryer must have been
spun beforehand. The
total weight of laundry
introduced may not exceed
7 kg
Consult a professional to
replace the temperature
fuse.
Make sure to clean the filter
regularly.
Clear out the duct.
Be careful not to overfill the
drum.
Take the laundry out
immediately after the cycle
is finished. See page 7.
Follow the label on the
clothing.
EN
C
Useful information
Problem
The laundry shrinks. Over-drying.
Synthetic and other coated
fibres often produce
Pilling on clothing.
pilling. This phenomenon
is due to friction.
• Noise from the dryer may be caused by:
Wet and heavy clothes spin and shake, causing noises.
• Shaking: during drying, the machine generates steam from a hose and this causes the
bottom of the drum to shake.
Description of other functions
Error code Description
The
Problem
temperature
with the
E3 sensor or the
temperature
circuit board is
sensor
defective.
The
Problem temperature
with the sensor is
E4
temperature weak or the
sensor circuit board is
defective.
13
Cause Solution
Follow the label on the
garments. If the fabric is
likely to shrink, examine
your clothes carefully when
dry. Take your laundry out
when it is not very wet or too
dry, then hang it out until it
is completely dry.
Use a fabric softener to
smooth the fibres. Spray
starch on sleeves and
collars when ironing. Dry
your clothes inside out to
reduce friction.
Criteria Action Status display
Interrupt the
The LEDs of
programme
the Low and
and have the
Standard
temperature
programs are
sensor
flashing
checked.
Interrupt the
programme
The LED of the
and have the
Extra program
temperature
flashes
sensor
checked.
EN